Sticker Application

1. Prep Your Surface !
First, make sure your surface is ready for the decal. It should be a clean, smooth, and dust-free surface. If necessary, wipe down the area before applying the decal. Just be sure the area is nice and dry before moving on to step two.

2. Pre-application !

Now that the surface is prepared, rub a squeegee or credit card firmly along the clear transfer-tape. This is to help ensure the sticker will cling to the transfer-tape and remove any air bubbles that may have formed.

3. Remove The Transfer Tape !
When you receive your decal or sticker, it will be covered with a layer of transfer tape and will still be attached to the material backing.
Slowly peel the tape from the backing at an angle while making sure the pieces don't stick to the backing. If the decal does stick, use a credit card to reattach the decal to the transfer tape.

4. Place The Decal !

Next, line the decal up on the desired surface. For precise application, measure and mark where you would like it before you place the decal. If you don’t like the placement at first, you can usually remove the transfer tape without the decal sticking to the new surface.
Once you are happy with the placement, apply the decal. Carefully line up the sticker at the top and slowly lower it until it lies flat on your surface. If you rush this step, you might end up with air bubbles and even a wrinkle in your vinyl. Press on the tape firmly with a squeegee from the middle to the edges.

5. Remove The Transfer-tape !

Carefully peel back the transfer-tape and you'll be left with an applied decal - Congratulations ! ฅ(≈≧ܫ≦≈)